Ss-cycle Closed Loop Oxygen Sensor Kit for Delphi Style S&a Manuel d'utilisateur télécharger pdf (Page 7)

16- Insert the white wire with an orange stripe into position #8. Next insert the white wire with the blue stripe into position #23, as shown in

Picture 13, below.

17- Conrm the terminals are all in proper alignment and reinstall the clear plastic cover. Now you can tuck the Sealed Electrical Tap into the

36-position connector cover and close it, making sure to get all the clips back in place. Finally, reinstall a wire tie at the base of the 36-position

connector. See Picture 14, below.

18- Conrm that there are two 15-amp fuses in the blue tap-a-fuse on the red wire. Then insert it into the fuel pump fuse slot as shown in Picture

15, below left. Take care not to disconnect the fuses as you slide it back into the fuse holder. See Picture 16, below right.

Picture 13

Picture 14

Picture 15 Picture 16

1 2 3 4 5 6 7 8

S&S 1
Cycle, Inc 1
17, below left 8
Picture 17 Picture 18 8

Commentaires sur ces manuels

Pas de commentaire

Ss-cycle Closed Loop Oxygen Sensor Kit for Delphi Style S&a Manuel d'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Pour les motocyclettes Ss-cycle Closed Loop Oxygen Sensor Kit for Delphi Style S&a