Ss-cycle Closed Loop Oxygen Sensor Kit for Delphi Style S&a Manuel d'utilisateur télécharger pdf (Page 5)

10- Continue running the S&S® wiring harness so the four wire ends are directly next to the 36-position ECM connector and fuse block area. Cut

the wire tie at the base of the main wiring harness where it meets with the 36-position gray connector. See Picture 7, below.

11- Carefully open the backside of the 36-position connector housing. See Picture 8, below.

12- Gently release the clips on each side of the clear plastic cover on the 36-position connector by pressing on each clip with a small at

screwdriver as shown in Picture 9, below.

Picture 7

Picture 8

Picture 9

1 2 3 4 5 6 7 8

Pas de commentaire

Ss-cycle Closed Loop Oxygen Sensor Kit for Delphi Style S&a Manuel d'utilisateur Page 5