Ss-cycle Secondary Drive Belt Handling and Installation Manuel d'utilisateur télécharger pdf

S&S

Cycle, Inc.

235 Causeway Blvd.

La Crosse, Wisconsin 54603

Phone: 608-627-1497 • Fax: 608-627-1488

Technical Service Phone: 608-627-TECH (8324)

Technical Service Email: sstech@sscycle.com

Website: www.sscycle.com

IMPORTANT NOTICE:

Statements in this instruction sheet preceded by the following words are of

special signicance.

WARNING

Means there is the possibility of injury to yourself or others.

CAUTION

Means there is the possibility of damage to the part or motorcycle.

NOTE

Other information of particular importance has been placed in italic type.

S&S recommends you take special notice of these items.

WARRANTY:

All S&S parts are guaranteed to the original purchaser to be free of

manufacturing defects in materials and workmanship for a period of twelve

(12) months from the date of purchase. Merchandise that fails to conform to

these conditions will be repaired or replaced at S&S’s option if the parts are

returned to us by the purchaser within the 12 month warranty period or within

10 days thereafter.

In the event warranty service is required, the original purchaser must call or

write S&S immediately with the problem. Some problems can be rectied by

a telephone call and need no further course of action.

A part that is suspect of being defective must not be replaced by a Dealer

without prior authorization from S&S. If it is deemed necessary for S&S to

make an evaluation to determine whether the part was defective, a return

authorization number must be obtained from S&S. The parts must be packaged

properly so as to not cause further damage and be returned prepaid to S&S

with a copy of the original invoice of purchase and a detailed letter outlining

the nature of the problem, how the part was used and the circumstances at

the time of failure. If after an evaluation has been made by S&S and the part

was found to be defective, repair, replacement or refund will be granted.

ADDITIONAL WARRANTY PROVISIONS:

(1) S&S shall have no obligation in the event an S&S part is modied by any

other person or organization.

(2) S&S shall have no obligation if an S&S part becomes defective in whole or in

part as a result of improper installation, improper maintenance, improper use,

abnormal operation, or any other misuse or mistreatment of the S&S part.

(3) S&S shall not be liable for any consequential or incidental damages

resulting from the failure of an S&S part, the breach of any warranties, the

failure to deliver, delay in delivery, delivery in non-conforming condition, or

for any other breach of contract or duty between S&S and a customer.

(4) S&S parts are designed exclusively for use in American v-twin motorcycles.

S&S shall have no warranty or liability obligation if an S&S part is used in any

other application.

SAFE INSTALLATION AND OPERATION RULES:

Before installing your new S&S part it is your responsibility to read and follow

the installation and maintenance procedures in these instructions and follow

the basic rules below for your personal safety.

Gasoline is extremely ammable and explosive under certain conditions

and toxic when breathed. Do not smoke. Perform installation in a well

ventilated area away from open ames or sparks.

If motorcycle has been running, wait until engine and exhaust pipes

have cooled down to avoid getting burned before performing any

installation steps.

Before performing any installation steps disconnect battery to eliminate

potential sparks and inadvertent engagement of starter while working

on electrical components.

Read instructions thoroughly and carefully so all procedures are

completely understood before performing any installation steps.

Contact S&S with any questions you may have if any steps are unclear or

any abnormalities occur during installation or operation of motorcycle

with a S&S part on it.

Consult an appropriate service manual for your motorcycle for correct

disassembly and reassembly procedures for any parts that need to be

removed to facilitate installation.

Use good judgement when performing installation and operating

motorcycle. Good judgement begins with a clear head. Don’t let

alcohol, drugs or fatigue impair your judgement. Start installation when

you are fresh.

Be sure all federal, state and local laws are obeyed with the installation.

For optimum performance and safety and to minimize potential

damage to carb or other components, use all mounting hardware that is

provided and follow all installation instructions.

Motorcycle exhaust fumes are toxic, poisonous and must not be breathed.

Run motorcycle in a well ventilated area where fumes can dissipate.

•

DISCLAIMER:

S&S parts are designed for high performance, o road, racing applications

and are intended for the very experienced rider only. The installation of

S&S parts may void or adversely eect your factory warranty. In addition

such installation and use may violate certain federal, state, and local laws,

rules and ordinances as well as other laws when used on motor vehicles

used on public highways, especially in states where pollution laws

may apply. Always check federal, state, and local laws before modifying

your motorcycle. It is the sole and exclusive responsibility of the user to

determine the suitability of the product for his or her use, and the user shall

assume all legal, personal injury risk and liability and all other obligations,

duties, and risks associated therewith.

Secondary Drive Belt Handling and Installation

Instruction 106-0883

07-30-07

by S&S® Cycle, Inc.

Printed in the U.S.A.

Because every industry has a leader

0095-1075

1 2

Cycle, Inc 1

Résumé du contenu

Page 1 - Cycle, Inc

S&S® Cycle, Inc.235 Causeway Blvd.La Crosse, Wisconsin 54603Phone: 608-627-1497 • Fax: 608-627-1488Technical Service Phone: 608-627-TECH (83

Page 2

2Proper Belt Handling: Improper belt handling before and during belt installation can dramatically shorten the life of a secondary drive belt. To avo

Commentaires sur ces manuels

Pas de commentaire

Ss-cycle Secondary Drive Belt Handling and Installation Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour les motocyclettes Ss-cycle Secondary Drive Belt Handling and Installation. S&S Cycle Secondary Drive Belt Handling and Installation User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour les motocyclettes Ss-cycle Secondary Drive Belt Handling and Installation