Ss-cycle Big Twin-Style Oil Pump Installation Manuel d'utilisateur télécharger pdf

S&S Cycle, Inc.

14025 County Hwy. G P.O. Box 215

Viola, Wisconsin 54664

Phone 608-627-1497 Fax 608-627-1488

Customer Service - [email protected]

Technical Assistance - [email protected]

Service Bulletin #31

Revised 2-02-99

by S&S Cycle, Inc.

S&S Service Bulletin #31

Big Twin-Style Oil Pump Installation

Picture 1 Picture 2

S&S recommends the following installation

procedure to insure correct oil pump operation.

Consult S&S Oil Pump Instructions #00-6250 or

Harley-Davidson service manual for additional

information as needed.

1. Confirm that adequate clearance exists

between oil pump body and crankcase by

temporarily installing pump assembly on

crankcase and inspecting areas indicated in

photo. See Picture 1. It may be necessary to

remove a small amount of material from oil

pump body to obtain correct fit. See Picture 2.

NOTE - Remove minimum amount of material

required for proper positioning of oil pump on

crankcase. Avoid damaging gasket surface if pump

body requires modification. After modification,

clean pump body thoroughly with suitable parts

cleaner solvent and compressed air to remove

metal filings generated during procedure. Remove

all traces of solvent prior to installation.

CAUTION - Failure to perform modification

correctly may result in oil pump damage not

covered under warranty. Do not use solvent that

could damage driveshaft seal in oil pump body.

WARNINGS

● Many solvents are flammable and potentially

toxic. Read solvent manufacturer’s instructions

prior to use.

● Compressed air is potentially harmful,

especially to eyes and skin. Wear goggles and

other protective clothing during use, and direct

air stream away from yourself and others

nearby.

2. Disassemble, clean, and inspect oil pump,

leaving supply drive gear, key, and snap ring in

place on shaft.

NOTE - In some instances, oil pump gears have

index marks. To assure proper gear mesh, marks

must align when gears are installed in pump body.

1 2

S&S Cycle, Inc 1

Résumé du contenu

Page 1 - S&S Cycle, Inc

1S&S Cycle, Inc.14025 County Hwy. G P.O. Box 215Viola, Wisconsin 54664Phone 608-627-1497 Fax 608-627-1488Customer Service - sscust@s

Page 2

2See Picture 3. Marks in photo have beendarkened. They normally appear as light punchmarks.CAUTION - Failure to align gear marks mayresult in bind an

Commentaires sur ces manuels

Pas de commentaire

Ss-cycle Big Twin-Style Oil Pump Installation Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour les motocyclettes Ss-cycle Big Twin-Style Oil Pump Installation. S&S Cycle Big Twin-Style Oil Pump Installation User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour les motocyclettes Ss-cycle Big Twin-Style Oil Pump Installation